Richmond, VA · Member since 2013 · 44 posts · 3 votes
Hi all,
Im looking at a 1940s SFR that has some sort of nailed on siding, short slabs nearly square not clear that its wood or not but has a wood texture. Anyway, im considering vinyl siding. Assuming I have a per square estimate, is it common to put vinyl over existing or do they tear out the existing?
Next, the house has a furnace with duct work throughout. Window ac units. Is it common or doable to replace the furnace with a heat pump/blower and use the existing duct work?
Finally, the electric panel is screw fuse type. Wiring looks good. Can i replace the panel as is with a modern breaker panel?
This one better be a great deal! Make sure it is not asbestos siding, that would be costly to abate. You can put siding directly over older stuff, but its nice to know that the sheeting under it is not rotted out. If I were keeping the house would probably take it down, inspect the sheeting, put up house wrap then vinyl. I am using hardi plank siding on my current project; I like it a lot more than vinyl, but a bit more expensive. They can typically use existing ductwork, just make sure that you have adequate air returns (often an issue remodeling older places). The electric paneling can potentially be replaced, but you should be certain that It does not have knob and tube or aluminum wiring. If it did you would need to rewire the entire house. Good luck!
Im looking at a 1940s SFR that has some sort of nailed on siding, short slabs nearly square not clear that its wood or not but has a wood texture. Anyway, im considering vinyl siding. Assuming I have a per square estimate, is it common to put vinyl over existing or do they tear out the existing?
Next, the house has a furnace with duct work throughout. Window ac units. Is it common or doable to replace the furnace with a heat pump/blower and use the existing duct work?
Finally, the electric panel is screw fuse type. Wiring looks good. Can i replace the panel as is with a modern breaker panel?
Thanks for any input,
Mike
The siding sounds like it might be masonite board or some sort.
Bring in an HVAC expert, you should be able to replace the furnace with a heat-pump.
You should also look at insulation (there will be minmal) and air sealing as you will likely get more bang for your buck with that than replacing the HVAC.
You should be able to replace the fuse box w/ a breaker panel ... the wiring in that house should be copper.
Could be asbestos siding. In that case, and depending on the exit price point of the house as well as the condition of the asbestos, I wouldn't eliminate the possibility of just painting it.
I've seen some really nice looking homes with painted asbestos siding. It's worth considering.
Asbestos siding didn't pop into my head right away - we do not see much of it around here; our asbestos is all in tiles, plaster and insulation. The house is the right age.
Mike B.
If the house has lath & plaster or rock board w/ plaster, asbestos is a possibility in the plaster for a house of that age. I would also look for an asbestos cloth wrapping (or plaster) on ductwork. Here the Vendor's would have to disclose the presence of asbestos (provided they know) ... I presume it would be the same in Virginia.
It is also possible for there to be knob-n-tube wiring, though not probable post-war. Aluminum wiring in residential applications didn't take hold until the 1960s when commodity prices for copper spiked, so, unless someone updated wiring in the 1960s/70s, it is unlikely you will find Al.
Our last rehab, we put the vinyl siding right over the mess that was there before. Regarding the duct work and electrical, I would call in a HVAC and Electrician.