Do It Yourself Donts

Do It Yourself Donts

Contractor · Anchorage, AK · Member since 2012 · 351 posts · 196 votes

Being that there are many more wrong ways to accomplish a given task than there are right ways I thought a thread covering some of the "donts" might be useful for those just getting their feet wet in repairs and renovations.

What have you seen done routinely that doesnt meet industry standards or even common sense?

What is the norm, isnt necessarily the best. What have you found to be a better method than how a given task is typically done in your area?

Note to newbies: Please dont take what I, or anyone else recommends as the gospel. Two "pros" may give two near opposite opinions on a given subject. Both may be right or acceptable, one or both may be wrong. My point is that it is wise to do your own research, drawing from various sources, and think it thru and decide for yourself.

I'll start it off with one o my biggest pet peaves.

NEVER use 100% silicone on a painted surface. You may walk away with it looking great, but the next guy to come along for a repaint, will have to remove the caulk because paint will bead up on it. Removing silicone from drywall is near impossible without removing the paint film its applied to. On textured drywall that often means scraping off paint and texture along with the silicone, patching, texture matching, and priming before paint.

There are three types of caulk most commonly used in renovations.

Latex caulk. AKA "painters caulk". Its a water soluable caulk used to fill and seal between two surfaces that will be painted. Left unpainted, latex will yellow, stain, catch dirt, and mildew.

Siliconized Acrylic caulk. A water soluable caulk with silicone added, used when filling and sealing between a painted and non-painted surface. While it is paintable, the silicone provides resistence to yellowing and staining.

100% silicone. NOT paintable. Used to fill an seal between two unpainted surfaces and the top choice for use in wet areas such as tubs and countertops.

These are general uses and some caulks are interchangeable, but this info should allow you to make the right choices in any given situation.

Not sure? If a tube of caulk does not say "paintable", it isnt paintable!

4Reply
127 views

Most Popular Reply

Rental Property Investor · Sacramento, CA · Member since 2011 · 2k+ posts · 1k+ votes
13y

Randy F. let me jump in with my biggest peeve - Don't be sloppy.

It only takes a minute to tape off an outlet or remove a wall plate. There is absolutely no reason to paint over an outlet or switch!

OK, let me calm down .... thanks for letting me get that off my chest.?

See this reply in the discussion

51 Replies

Jump to latestLatest
  • Real Estate Investor · Audubon, PA · Member since 2009 · 13k+ posts · 8k+ votes
    12y
    Originally posted by @Jaime Penix:
    Originally posted by @Steve Babiak:
    Gas heaters and hot water heaters installed without a drip leg.
    Improperly vented exhaust from gas heaters and hot water heaters.

    The electrical junction box on the basement ceiling that has no cover plate.

    Laundry washing machine drain hookup done as an open-ended pipe but without any trap.

    Interesting. I ran across a situation just recently. Can a hot water heater without a "drip leg" or one that has a drip leg that is not horizontal explode?

    The drip leg is for the gas supply line. I believe you were referring to the discharge pipe from the pressure relief valve, and that usually isn't called a "drip leg".

Join the conversationCreate a free account to reply, vote on answers and follow this thread.