Classifieds
Market News & Data
General Info
Real Estate Strategies
Short-Term & Vacation Rental Discussions
presented by

Landlording & Rental Properties
Real Estate Professionals
Financial, Tax, & Legal
Creative Real Estate Financing
presented by

Tax, SDIRAs & Cost Segregation
presented by

1031 Exchanges
presented by

Real Estate Classifieds
Reviews & Feedback
Updated about 9 years ago on .

How To: Dry Out Your Structure After a Water Damage in 10 Steps.
- Extract all water from carpet and pad, and for even faster dry times pull back the carpet and remove the pad. If you remove the pad a shop vac or other non-commercial wet vacuum may be enough.
- check the walls with a moisture meter, if they are much more than 20% saturated then remove the base boards. Depending on the material they can be saved for reuse. You can start the first day by popping them out 1-2 inches.
- Check Relative Humidity Levels. They should be below 40% RH by day two if possible.
- If the walls are saturated at near 100% consider a 2ft cut to remove the drywall that is wet. We always cut in 2ft increments as it makes put-back cheaper and easier.
- Place low voltage air movers and Low Grain Dehumidifiers in the space. You should have at least one air mover floating the carpet. and others moving air over every effected surface. Dehumidifiers are more complicated.
- Find the AHAM rating for the dehumidifier.
- Next determine the cubic footage of your affected area (this is any area that is connected to the problem area and cannot be closed off behind a door. If you are not familiar with this calculation take the floor area (width x length) multiply it by the height of the ceiling. If there are multiple ceiling heights perform 2 (or more as needed) calculations and add them together. Sometimes Trigonometry can be used in special room configuration situations or a conservative estimate can be used.
- The formula: Divide Cubic Footage of Affected Area by the Class Divisor (see chart below) = Pints of Dehumidification required divide by the Pints Per Day AHAM Rating I told you to find in step 5 to get the Number of Units Required for the job.
Divisor Class 1 Class 2 Class 3 Class 4 LGR 100 50 40 50 - Wait 24 hours and then Check Humidity again and walls and other structures. Make changes in air movement and dehumidification as needed and repeat every 24 hours as needed until dry.
- If this Sounds like more than you want to take care of calculate or keep track of, or if you need to file for an insurance claim. Marvelous Restoration serves the greater Kansas City Metro. Give us a call: 816-837-0083 ASAP after you find out about the water loss. Even in the middle of the night we are on call and can help you mitigate (prevent) further loss!
- If you have questions feel free to connect and also email [email protected]
- I would love to know if you find this helpful message or connect with me and that will help me decide the type of how-to articles I write in the future. Thanks!
- Disclaimer: This is a basic list of steps for informational purposes, it might be altered by a professional onsite. There can be more complexities and steps required depending on the situation. We make no guarantees regarding this process and accept no liability if you choose to try it on your own.
When there is water in your rental unit the goal is to dry everything ASAP! You are probably thinking duh! Well, now I will tell you how to dry as fast as possible:
Offering