12 December 2017 | 15 replies
If there is a sliding door, those are even easier to get in through.
14 October 2021 | 105 replies
All-in, I bet rent increases need to be 7-10% minimum just to keep from sliding backwards, and if I don’t budget properly for those increases in order to make the mortgage payments, we’re all homeless together.
17 May 2023 | 29 replies
I also disliked that I couldn't make a custom application, but I could let this slide since I require that applicants fill out a custom Google Form anyway.I'm hopeful that they will address these issues soon!
5 September 2019 | 80 replies
However, keep in mind a place being used for STR arbitrage is viewed as an asset and is treated as such (minor repairs made regularly often without bothering you and cleaned between each stay), whereas even the BEST tennants in the world view your property as a liability and will let cleanliness and minor stuff slide over time.
8 February 2021 | 19 replies
For the plumbing you can usually get a one-piece boot that slides down over the top of the pipe.
26 September 2016 | 7 replies
Some localities will require that glass that isn't above a certain height above the floor will have to be tempered (also true for windows in a bathroom).
14 September 2019 | 14 replies
Why are you wanting to use glass block?
18 April 2017 | 6 replies
Also there are sliding mirrored doored closets off the hallway and vanity areas.
29 April 2018 | 6 replies
If the hinge pins are worn, the door can move a little bit left and right in the frame - imagine that the door is closed and you are pushing sideways on the door knob, pushing the knob towards the frame, as if it were a sliding door - that's the direction it would move in.To check the pins, you can either use a screwdriver to pry the hinge pin up a little and then pliers to remove it the rest of the way, or use a hammer and a nail to knock the hinge pin out of the hinge.
12 September 2018 | 12 replies
Even before doing that it could be beneficial to get a contractor out there to quote the job as you'll have his measurements for validation and he might point out things you might have missed (where tempered glass is needed, where jamb extension might be needed, potential one-off issues...etc).